Renovating, extending or subdividing? Your electricity meter may need to move to a compliant, accessible location. We handle the switchboard works, wiring, network requirements and metering coordination so your meter relocation does not hold up your build.
Australian Owned & OperatedWork completed in accordance with applicable NSW network, metering and electrical requirements.
Common reasons include a wall being demolished or built over, a garage conversion, subdividing a block, or a meter that is currently inaccessible to meter readers and emergency services. Networks require meters to be in accessible, protected locations — and non-compliant positions attract defect notices.
We plan the new metering position to meet distributor requirements, install the new board or enclosure, run the necessary wiring, and coordinate the meter exchange or transfer with your retailer. Where the relocation coincides with a renovation, we schedule around your builder to avoid delays.
Meters must remain accessible to your network distributor and metering provider. We advise on compliant options — including reading windows and approved enclosures — for your specific site.
The physical works usually take one day. Total time depends on retailer scheduling for the meter transfer, which we coordinate on your behalf.
Full compliance upgrades to ensure your switchboard meets current network standards.
Learn MoreComplete end-to-end installation and coordination for residential and commercial properties.
Learn MoreUpgrading the main power cables to your property to support higher capacity connections.
Learn MoreFill out the form below and our team will get back to you fast.